Why would both low beam headlights stopped working?

Solution: If both headlights aren’t working, it’s unlikely that a bulb is at fault. The likely cause is a fuse, headlight relay, headlight switch, dimmer switch or a wiring fault. … Consult your owner’s manual to locate the main fuse for the headlight circuit and replace that fuse with one having the same amp rating.

What would cause both low beam headlights out?

Most total headlight failures are caused by a bad component like a fuse, relay, or module. Wiring problems can also cause both headlights to stop working. … The cause: A burned out bulb, or a problem with the high beam switch or relay. The fix: Replace the bulb, switch, or relay.

Why does high beam work but not low beam?

Headlight Fuse or Relay

If a headlight fuse blows, it could cause the headlights to stop working. Most headlight systems are also designed with a relay that switches the power between low beam and high beam headlights. If this relay goes bad, it could allow power to the high beams, but not the low beams.

How do you fix low beam headlights not working?

4 Steps to Fix a Low Beam Headlight Bulb

  1. Find the blown out bulb. …
  2. Buy the replacement bulb. …
  3. Get your tools ready. …
  4. Disconnect the negative terminal on the battery. …
  5. Remove the trim pieces. …
  6. Find the headlight holder. …
  7. Disconnect the cables from the headlight. …
  8. Remove the headlight bulb from the bulb housing.
IT IS INTERESTING:  Do they check headlights for inspection?

Is there a fuse for low beam lights?

Like all electrical systems, the headlights in your vehicle have a fuse in the circuit to prevent too much electricity from reaching the bulb. There will also be a headlight relay that switches power from the low beams to the high beams. If the fuse goes bad, you likely won’t have any headlights at all.

What are the symptoms of a bad headlight relay?

Headlights Don’t Turn On

The most common sign of a bad headlight relay is headlights that don’t work. A headlight relay will typically fail in the open position, preventing voltage from reaching the headlights. If the low beam relay fails, the low beams won’t work.

How much does it cost to replace a headlight relay switch?

The average cost of replacing the headlight switch or the dimmer switch is in the range of $150-$250. Sometimes, accidents can damage the headlight and you are left with no option but to replace the entire assembly unit.

Why are my low beam lights so dim?

Most DIYers think they’ve got a bad headlight switch or a bad connection in the power feed. But most dim headlights are caused by a corroded ground wire. … Another possibility is that as headlight filaments age, they deposit a gray/brown film on the inside of the bulb (See Photo).

Do low beams and high beams use the same bulb?

Generally, you’ll have a standard halogen bulb for low beams, and then an HID bulb for your high beams. These are not interchangeable. … If you only have two headlight elements (one per side), then your vehicle uses a dual filament bulb to operate both the high and low beams.

IT IS INTERESTING:  How do you open a small flashlight?

How do you diagnose headlight problems?

Diagnosing the issue is a straightforward process.

  1. Turn on your headlights. Replace whichever headlight bulbs do not turn on. …
  2. Open the engine compartment fuse box. Pull the fuse that operates on the non-functioning headlight circuit. …
  3. Connect the negative lead of the voltmeter to the negative terminal on the car battery.
Categories LED